ISSA - HKM ASW 28 Wing Servos and Canopy Latch

Building the HKM 1:2.5 ASW 28 Rick Briggs
Wing Servos and Canopy Latch Just when you thought I was done. The wing servos are pretty standard, I’m using Hitec 5945 dig. The servo frames are a new item. There from Germany and Craig Greening is the US distributor at http://www.servoframes.com/ these are for JR but you can modify to fit Hitec. I really like these because you can easily remove the servo. On to the Canopy Frame, the latch and pull are made from a latch you can get at Hobby Lobby.
Photo: Rick Briggs	Servo frame from http://www.servoframes.com/. Its a JR 8411 frame modified to fit Hitec.
Photo: Rick Briggs	I use carbon mat to reinforce the wing skin.
Photo: Rick Briggs	Here is a Hobby Lobby canopy latch part nr. GR8066 sauder a pece of brass to the lever to recive the cable. I made a ply wedge stand off and glassed the latch in place. Use a micro cable and tube drill a hole in top of the landing gear bulkhead and CA th
Photo: Rick Briggs	Exit the tube and cable out the bottom of the wing fareing CA the other end of the tube and cut off. Sauder a brass ball link to end of the cable about 1/2" inch.